ETU++
$60.27
The prices shown are gross prices for customers from European Union countries, which means they include VAT. For customers outside the EU, prices are displayed as net, excluding VAT. For orders from outside the EU, any customs duties and additional import-related costs are the responsibility of the buyer. The price displayed on the website is calculated based on your location. However, please note that the system may occasionally determine your location incorrectly. The exact price, including tax, will be shown after entering the shipping address in the cart, before placing the order.
ETU++ is a system that replaces the standard electronics in G&G replicas equipped with the ETU system. It enriches the replica with many new, useful features. Simply disconnect the factory-installed electronic board in the stock and plug in the ETU++. The factory contacts in the gearbox are preserved, so there is no need to open it.
It works with any replica equipped with the ETU system from G&G, as well as with 7.4V, 11.1V, and 14.8V Li-Po batteries.
Online store will be opened in the future
Upgrade your G&G replica with an ETU system
Fully programmable fire modes – at each selector position (except “safe”), you can set semi-automatic, burst, or full-automatic fire independently of the other positions.
Active brake – Stops the motor after each shot, preventing “whipping” of the spring, and in the case of faster replicas – does not allow overspin (double shot instead of single).
Rate of fire reduction – reduce the rate of fire in automatic or burst mode to save ammunition or increase realism.
Precocking – A quick response to a trigger press can make the difference between winning and losing, especially during indoor battles. When precocking is enabled, the piston remains in the rear position after each shot, allowing the shot to be fired immediately when the trigger is pulled. To release the spring after using precocking, pull and hold the trigger for 2 seconds. Second shot will be fired, this time with no precocking and fully braked.
Binary trigger – Allows for easy double shots in semi-automatic setting. When this mode is enabled, single shots will be fired not only when the trigger is pulled but also when it is released.
DMR mode – Introduces intervals between semiautomatic shots to comply with DMR rules on some fields.
Security
Discharged battery alarm – Designed for Li-Po and Li-Ion batteries. If the battery voltage drops to a dangerously low level, the user will be notified by short audible signals repeated every minute.
Diagnostic system – Constantly checks the condition of the electronics and the replica. In the event of a problem, it will immediately provide information about the possible cause, making troubleshooting easier.
Electronic fuse – protects the replica and the battery in the event of a serious malfunction. It will automatically disconnect the battery if a short circuit is detected or if a jam occurs in the gearbox.
Easy to change settings
Programming of all the settings is done solely by using quick and easily memorable sequences of fire selector switching and trigger pulls supported by sound signals and multicolor LED diode. The chip communicates with the user via beeps and a multicolored LED. That allows changing the settings in any moment, in a matter of seconds, even under enemy fire. All settings are set independently for each selector position, so you can program the mosfet exactly the way you want, for example semi on semi and binary trigger on auto.
ETU++ works without problems with any battery from 7V do 17V. It can also be used with most extreme setups, without any limitations as to the spring rating. The maximum rate of fire is 50 RPS.
| Version | Standard (T-Dean plug), Semi-only (T-Dean plug) |
|---|
Only logged in customers who have purchased this product may leave a review.
Reviews
There are no reviews yet.